Hanlong UC802(P) - End a Call

Table of Content
56
To place a call by call history or Directory
1. Press the History soft key (On the idle page) or Menu → History /Directory
2. Press
and
to select the targeted one.
3. Press Send soft key to make the call.
Note:
1. The key is set to be a send key. You can set the * key as send key or set some other to be
as send keys. For more information, refer to the Key as Send on page
2. During the call, you can also change among Headset, Handset or Free-speaker mode.
Making two calls with one line and one account
1. Press a line key and dial one phone number, then make a call.
2. Press the corresponding line key
3. Dial another phone number,
4. Press the Send soft key, or
, then make the second call.
End a Call
Here shows to end a call during three modes:
To end a call by Handset
1. Press the Cancel soft key or hang up the handset, or press
To end a call under Headset Mode
1. Press the Cancel soft key or press
, or press .
To end a call under hands-free speakerphone Mode
1. Press the Cancel soft key or press
, or press .
Note:
During the conference, to end the call is same as mentioned above.