Programmable Temperature & Humidity Controller
26
▶ DI state screen
①
②
③
④
No. Description
1
Displays selected DI image. The image can be copied in [System] – [Main menu] - [System menu].
Image is sized to 310 X 210.
2
Displays selected DI name. It can be set in [System] – [Main menu] - [System menu].
3
Turns off buzzer for DI.
4
Select DI. If DI is colored in red, DI contact is ON.
Picture 23) DI status screen
Picture 23-1) DI status screen2
●
Step/Hold
This function is enabled only during program operation. Enter a key or set Hold/Step in [System menu]
– [DI configuration] – [Configuration type] and then set external contact input2(DI2) to ON for Hold or
external contact input3(DI3) to ON for Step.
Parameter Description
Stop the operation of current segment and continue with next segment operation.
Run Step in Wait or Hold state to cancel it and continue with next segment.
During Hold, press Hold button again to cancel it and run the program.
step
HOLD
هﺮﮐ ﮓﻧﺎﯿﻧﺎﻫ تﻻﻮﺼﺤﻣ یرﺎﺼﺤﻧا هﺪﻨﯾﺎ ناﻮﯿﺳ ﺖﮐﴍ
To Next Page
Loading...
Need help?
General
