Hanyoung NP100 - Program Setup Parameters; Pattern Number and Segment Configuration; Start Value, Type, and Time Signal Settings; Program Completion Modes and PID Assignments

Signal
Setup range
Display
condition
Initial value
Program setup group
0~10
Within range
Always
on pattern
selection
on pattern
selection
on pattern
selection
on pattern
selection
on pattern
selection
on pattern
selection
on pattern
selection
PID control
Always
0
-200
SSV
OFF
OFF
OFF
OFF
RST(RESET)
1
-200
Patter number
selection
Item
Setup of n. pattern time
signal-1 ON time
Setup of n. pattern time
signal-1 OFF time
Setup of n. pattern time
signal-2 OFF time
Setup of n. pattern time
signal-2 ON time
Program
completion mode
n pattern 1 segment PID
group no. selection
Target set value
Setup of n pattern 1
segment time
n pattern 10 segment
PID group no. selection
Target set value
Setup of n pattern 10
segment time
SSV : Start SV
PV : Process value
It sets up the program to be controlled after finishing
the engineering mode setup.
OFF / 00.00~99.59
OFF / 00.00~99.59
(ON time < OFF time)
OFF / 00.00~99.59
OFF / 00.00~99.59
(ON time < OFF time)
RST/HOLD/PT-1/PT-2
0~10
Within range
OFF / 00.00~99.59
(Time unit is set at the
control setup group)
1~4
Within range
OFF / 00.00~99.59
(Time unit is set at the
control setup group)
Always
Always
PID control
Always
OFF
OFF
1
-200
NP100
1) Selection of Pattern Number
: NP100 temperature controller can set up pattern 1, and pattern 2. Select “pattern 1” to operate in the
setup item of pattern number selection. (Pattern refers to one setup program.)
2) Selection of segment number
: It is designed to set up to 10 segments for each pattern. At the beginning, choose
0 segment then
set up basic condition of the program.
Segment number
( 1 ~ 10 )
0~10
Segment number
selection ( 1 ~ 10 )
Always
10
“0” segment setup
Setup of
start set value
Start type selection
1 or 2 pattern
Always 1