Hanyoung NP100 - 5. INPUT & OUTPUT; Input Wiring and Range Specifications; Control Output Types and Wiring

Retransmission/SPS
-
ON OFF control* - -
Relay - -
Output 1 Output 2
Control type
SSR / SCR (Current)
RET / SPS
Display range : -5 % ~ +105 % of range 1 : below 0 : 0.2 % of F.S 1digit
2 : 0 ~ 400 : 5 % of F.S 2digit
Control output type
Input type and Measurement range
SSR -
SCR -
~ : Terminal number SPS: Power supply for exernal sensor
Thermocouple
(T.C)
R.T.D
Direct voltage
(V)
Direct voltage
(mV)
Scaling range
SL-L ~ SL-H = -1999 ~ 9999
**When using current input, use the
resistor 250
0.1% on input termi-
nal to use 4~20mA DC input.
0.10 % of F.S
1digit
0.15 % of F.S
1digit
0.1 % of F.S 1digit
0.2 % of F.S 1digit
0.1 % of F.S 1digit
Input type Code
Range ( )
Accuracy
K
K
J
E
T
R
B
S
L
N
U
W
Platinel
JPT100
PT100
1~5V**
0~10V
-10~20 mV
0~100 mV
-200 - 1370
-199.9 - 999.9
-199.9 - 999.9
-199.9 - 999.9
-199.9 - 400.0
0 - 1700
0 - 1800
0 - 1700
-199.9 - 900.0
-200 - 1300
-199.9 - 400.0
0 - 2300
0 - 1390
-199.9 - 500.0
-199.9 - 640.0
*1
*1
*1
*1
*1
*2
*1
*1
Caution Measurement Input Wiring
- When wiring the input line, cut off the controller and the external power.
- Be careful with polarity and wire the input signal at some interval from power circuit and ground
connection circuit.
- Use shielded input cable when wiring and earth the shield 1 point.
Caution Control output wiring
- In case of wiring or eliminating the control output, cut off the controller and the external power.
- Use a shielded line for SSR pulse or Current output when wiring.
Relay
NP100