HARVEY Hydroclave MC8 - Page 47

47
Press PROGRAM/SET
Press PROGRAM/SET
Press PROGRAM/SET
Press PROGRAM/SET
3. When RECIRCULATE is displayed,
press either the up or down arrow to
change to NON-RECIRCULATE.
Press UP or DOWN arrow.
Press PROGRAM/SET.
4. Press CYCLE STOP to exit setup
mode.
5. Press CONTROLS ON and select your
desired cycle.
RECIRCULATE
CONFIGURATION
HARVEY
MODEL MC8 OR
MC10
DECIMAL POINT
“.”
STANDARD UNIT
CYCLE COUNT
XXXXX
INSTALLATION