Application
T10FS A0785-150 HBM: public 15
3 Application
T10FS torque flanges record static and dynamic torque
on fixed or rotating shafts and also return RS-422 signals
with direction of rotation information to determine the
speed. With an optical speed measuring system, a
reference pulse can also be output with the speed
pulses. Test beds can be extremely compact because of
the short construction of the measurement flanges. They
offer a very wide range of applications.
In addition to conventional test‐bench engineering
(engine, roll and transmission test benches), new
solutions are possible for torque measurements partly
integrated in the machines. Here, you benefit in full from
the T10FS torque flange special characteristics:
low rotor weights
low mass moments of inertia
small outside diameters
no bearings, no slip rings
Thanks to the bearing‐free design and the contactless
transmission of excitation voltage and measured values,
there are no friction or bearing heating effects.
Torque flanges are supplied for nominal (rated) torques
from 100 N⋅m to 10 kN⋅m. Depending on the nominal
(rated) torque, maximum speeds of up to 24 000 min
-1
are permissible.
T10FS torque flanges are reliably protected against
electromagnetic interference. They have been tested with
regard to EMC according to the relevant European
standards, and carry the CE mark.
To Next Page
Loading...
Need help?
General
