To Next Page

To Previous Page

Mechanical installation

38 A0785-150 HBM: public T10FS

5.9 Aligning the stator (speed measuring

system)

The stator can be mounted in any position (for example,

“upside down" installation is possible).

For measuring mode to operate perfectly, the speed

sensor (pole ring/slotted disc) of the speed measuring

system must be positioned at a defined point to the

sensor.

Notice

To attach the stator, we recommend the use of M6

screws with plain washers (width of oblong hole, 9 mm).

This size of screw guarantees the necessary travel for

alignment.

5.9.1 Magnetic speed measuring system

Notice

With the magnetic speed measuring system, the stator

pole ring and stator sensor head are perfectly matched to

each other. To maintain the specified pulse quality, the

transducer components provided in multiple deliveries

must not be mixed up. Before installation, compare the

identification numbers of the rotor and stator (also see

note on Page 24)!

Questions and Answers:

Need help?

Do you have a question about the HBM T10FS and is the answer not in the manual?

HBM T10FS Specifications

General