HBM T10FS User Manual

Settings
T10FS A0785-150 HBM: public 61
the installation. The balancing range is a minimum of
±400 mV at nominal (rated) gain. The end point
potentiometer is used for compensation at the factory
and is capped with varnish so that it cannot be turned
unintentionally.
Important
Turning the end point potentiometer changes the factory
calibration of the voltage output.
Zero point
End point
Fig. 8.4 Setting the voltage output zero point

HBM T10FS Specifications

General

Brand	HBM
Model	T10FS
Category	Measuring Instruments
Language	English