HEADRUSH PRIME - 4.0 Operation; 4.1 Main Screen

10
(4.0) Operation
This chapter describes HeadRush Prime’s functions.
(4.1) Main Screen
(4.1.1) Overview
(4.1.2) Basic Operations
Important: The sequence of blocks in your signal chain is not necessarily reflected in the footswitches. You can
freely assign blocks to available footswitches without changing your signal chain at all—and vice versa. See (4.6.1)
Hardware Assign > Footswitches to learn about this.
To assign a block (amp, cab, impulse response, or effect) to an empty slot, tap the () icon and then use the list
that appears. See (4.3.1) Rigs > Creating a New Rig to learn about this.
To show a block’s Detailed Settings screen, double-tap it. Its settings screen will appear with its preset menu,
parameters, and assigned color. See (4.4) Adjusting Settings to learn about this.
To show a block’s parameters on the right edge of the screen, tap the block so it is outlined in green. You can
then turn the parameter knobs to adjust the parameters to their left. If a block has more than three parameters
that you would like to adjust, drag your finger up or down the column to bring the additional parameters into
focus. When no block is selected, the parameters will be ones that you assign in the (4.6) Hardware Assign screen.
To rearrange the blocks in your signal chain, tap and drag a block to another slot or
between two other blocks (the ones after that position will shift one slot further down
the signal chain).
Tap to view the Hardware
Assign screen.
Tap and drag this bar downward to view the
Rig List screen. Double-tap to rename the rig.
Tap to create
a new rig.
Tap to view the Menu screen and
access more features and settings.
Double-tap to view the
Input Settings screen.
Double-tap an effect,
amp, or cab to view its
Detailed Settings
screen.
Turn the parameter knobs to
adjust the corresponding
parameters. If a block has more
than three parameters, drag
your finger up or down this
column to bring the additional
parameters into focus.
This button enables or
disables reverb and
delay tails when
switching to another rig.
Tap to turn on/off the dry
microphone input when
using a signal chain type
without vocal FX.
Tap to change the
signal chain type
(guitar, vocal,
guitar/vocal, etc.).
Double-tap to view
the Output Settings
screen.
Tap to save
the rig.
Turn the encoder to
move through selectable
items onscreen or to
adjust parameters. Press
the encoder as an Enter
command.