HEADRUSH PRIME - (4.14.1) Additional Looper Settings

42
(4.14.1) Additional Looper Settings
To access additional looper settings, tap the settings
icon in the top right of the looper screen.
The following parameters are available on this screen:
• Global Tempo Sync: Set this parameter to On to set
the Looper to sync to HeadRush Prime’s Global Tempo.
This is the same tempo used for any effects that are set
to “Sync,” as well as the Metronome feature. Set this
parameter to Off to desync the Looper tempo from the
global tempo.
• Global Tempo: Use this parameter to manually set the
global tempo of HeadRush Prime using the main
encoder. You can alternately set this tempo by using
the tap tempo footswitch.
• Metronome: Set this parameter to Rec (record) to have the metronome only play while the initial layer of the
loop is being recorded. Set this parameter to On to have the metronome play while the loop is recording,
playing, and overdubbing a layer. Set this parameter to Off to disable the metronome.
• Count-In: Use this parameter to determine a 1–4 Bar count-in before a loop begins recording the initial loop
layer. Set this parameter to Off to disable to the count-in bar and begin recording the initial loop layer instantly.
• Time Sig: Use this parameter to determine the time signature of the count-in.
• MIDI Beat Clock: Set this parameter to On to set HeadRush Prime’s looper to sync to the tempo of a connected
external MIDI device. Set this parameter to Off to disable sending MIDI sync.