59
(4.22) External MIDI Control
HeadRush Prime can be controlled by incoming MIDI CC (control change) messages sent by external MIDI gear.
This external MIDI gear must be connected to the 5-pin MIDI Input or the USB-B connection. If USB-MIDI gear is
being connected to the USB-B port, it must be class compliant and require no software drivers to function.
The chart below lists the parameters that can be controlled by external MIDI hardware:
CC# Action CC# Action
49 Footswitch 1 71 Looper Insert
50 Footswitch 2 72 Looper Peel
51 Footswitch 3 73 Looper Mute
52 Footswitch 4 74 Looper Reverse
53 Footswitch 5 75 Block 1 Toggle ON/OFF
54 Footswitch 6 76 Block 2 Toggle ON/OFF
55 Footswitch 7 77 Block 3 Toggle ON/OFF
56 Footswitch 8 78 Block 4 Toggle ON/OFF
57 Footswitch 9 79 Block 5 Toggle ON/OFF
58 Footswitch 10 80 Block 6 Toggle ON/OFF
59 Footswitch 11 81 Block 7 Toggle ON/OFF
60 Footswitch 12 82 Block 8 Toggle ON/OFF
64 Tap Tempo 83 Block 9 Toggle ON/OFF
65 Looper 1/2 Speed 84 Block 10 Toggle ON/OFF
66 Looper 2X Speed 85 Block 11 Toggle ON/OFF
67 Looper 1/2 Loop 86 Block 12 Toggle ON/OFF
68 Looper 2X Loop 87 Block 13 Toggle ON/OFF
69 Looper Start/Stop 88 Block 14 Toggle ON/OFF
70 Looper Record
To Next Page
Loading...
