16
The lack of water warning will show in the right of display area when the pressure of
feed water is too low or no feed water. The main unit will stop to standby status. The main
unit will re-start to flush automatically when the water comes again, as shown below:
When the flushing process of main unit is finished, the system will automatically enter
the water producing state. The Smart-Mini will flushing automatically RO membrane before
and after producing RO water. The system also shows water conductivity and RO
deionization
rate
. But the Smart-Mini system will enter the standby mode. As shown below:
Smart-Mini has manual flush function for RO membrane cartridge, press the "Flush /
▼
" to flush RO membrane cartridge manually for 1 minute. At this time the LCD display of the
main unit is the same as flushing mode from the beginning.
Press the "Stop /
"keypad to stop flushing operation. LCD will display the next
current-status.
To Next Page
Loading...