Heal Force Smart-Mini - Chapter 7 Troubleshooting; No Display; Making RO Water Is too Low

40
Chapter 7 Troubleshooting
7.1 No display
Description
Solution
No power supply for power outlet
Confirm power outlet is normal
Electrical outlet loose
Change electrical outlet
System power cord is not properly installed
Make sure the power cord is plugged into the
electrical outlet of main unit
system power is turned off
Turn on the power switch on the back of the
main unit
Power cord is damaged
Change the power cord
Fuse burned
Change fuse
Internal component failure
Contact Technical service
7.2 Making RO water is too low
Description
Solution
No feed water supply, warning for water shut
off
confirm the patency of external water supply
Pre-filter blocked, warning for no water
Rinse the filter and replace it when necessary
Feed water pressure is too low, indicating no
water warning
Needs another pressure pump
water supply connection error, indicating no
water warning
Make sure that feed water pipe connecting to
the FEED connector of the main unit.
Pretreatment blocked
Replace the pretreatment module
There are impurities on the RO surface
Press
“
Flush/
▼”
button to flush RO
RO blocked
Replace the RO module
Pure water outlet connection error
Verify that the RO OUT of main unit
connected with RO IN of water tank
Water temperature is too low
Add the preheat system
Internal component failure
Contact Technical service