HEIDELBERG Wallbox connect.home User Manual

32
English
LEDdisplay Description
Illuminated red
Connection error.
IfthereisnoWLANconnection:
•ChecktheWLANrouter.Routeroutofrange
or switched off.
•ResettheWLANconnectionifnecessary.
IfthereisnoLANconnection:
•CheckLANcableconnection.
Flashingred
Connectiontothenetworkbutnottotheinternet.
Checkyourrouterconguration.
5redashes
WLANconnectionclearedorfailed.
The charging system is returned to Hotspot mode.
Illuminated
yellow
Hotspotmodeactive,readytoestablishWLANconnection.
Additionalinstructionsviatheapp.
Alternately
illuminated
yellow/green
WPS mode active.
Flashingyellow
Connectiontothehotspothasbeenestablished:
•Followtheinstructionsintheapp.
Flashinggreen
Connectiontotherouterhasbeenestablished.
Establishing a connection with the server.
Illuminated
green
Connectiontotheserverhasbeenestablished.
LEDoff
Communicationmoduleactiveandinpowersavingmode,orchargingsystemswitchedoff.
BrieypressingtheConnectbuttonwillindicatethecurrentdevicestateviatheLED.
Meanings of the Status LED on the communication module
Resetting WLAN connection
1. Switch off the power supply for the charging system
and then switch it back on after 3 seconds.
Thecommunicationmodule'sWLANconnectioncan
nowberesetwithinthenext20minutes.
2. Wait until the charging system is ready for operation
(StatusLEDofthechargingsystemlightsupblue).
3. PresstheConnectbuttononthecommunication
moduleforapprox.3secondsuntiltheLEDbriey
lightsupred.ReleasetheConnectbutton.
TheLEDashesredvetimes.TheexistingWLAN
connectionwillbereset.AnewWLANconnection
canbeestablishedassoonastheLEDlightsupyellow .
4. If necessary, carry out the steps from the “Setting up
thenetworkconnection”chapter.
Resetting the communication module to the factory
settings
Resetting to the factory settings will delete custom
settingssuchasauthentication,taught-inRFIDcards
orWLANpasswords.
Perform the following steps to reset the communication
moduletothefactorysettings:
1. Switch off the power supply for the charging system
and then switch it back on after 3 seconds.
The communication module's factory settings can
nowberestoredwithinthenext20minutes.
2. Wait until the charging system is ready for operation
(StatusLEDofthechargingsystemlightsupblue).
3. PresstheConnectbuttononthecommunication
module and hold it for 15 seconds until the display
LEDlightsupredtwice.
4. ReleasetheConnectbutton.
The communication module restarts and is reset to
the factory settings. This can take up to 90 seconds.
5. If necessary, carry out the steps from the “Setting up
thenetworkconnection”chapter.
Hardware reset
Youcanrestartthecommunicationmodulebyper-
formingahardwarereset.Yourcustomsettingswillbe
retained.Usingapointedobject,presstheResetbutton
on the communication module for 1 second.
3 4 5 6 71 2
Connectivity

HEIDELBERG Wallbox connect.home Specifications

General

Brand	HEIDELBERG
Model	Wallbox connect.home
Category	Automobile Accessories
Language	English