HEIDENHAIN MANUALPLUS 4110 - Creating the Form Roll Cycle Program: Cycle Setup; Creating a Cycle Program for Form Roll; Defining the Blank-bar;tube Cycle for Form Roll

HEIDENHAIN MANUALplus 4110 Recess Machining Example 9.2
Create the “Form roll” cycle program
Creating a cycle program
Program the cycle “Blank—bar/tube”
 Activate “Teach-in”
 Enter the program number and name
 Press the Add cycle soft
key
 Press the Define blank
menu key
 Press the Blank – Bar/Tube
menu key
Enter the cycle parameters:
 Outside diameter X: 60 mm
 Length Z: 75 mm
 Inside diameter I: No entry
 Right edge K: 1mm
 Clamping range B: 20 mm
 Type of clamping J: 1
 Press the Input finished
soft key
 Test the cycle:
Press the Graphics soft key