HEIDENHAIN MANUALPLUS 4110 - Adjusting Simulation View; Using Zoom Functions for Detail; Changing the Image Section

HEIDENHAIN MANUALplus 4110 Graphic Simulation 10.3
Enlarging, reducing, selecting a section for enlargement
Zoom functions
The zoom functions can be used to isolate a detail and magnify/reduce the displayed graphics.
Change the image section
Initial situation
 Call the zoom functions:
Press the Zoom soft key
The red rectangle indicates the selected
section.
 Reduce the section:
Press the Page forward
key
 Increase the section:
Press the Page back key
 Move the section:
Press the arrow keys
 Assume the selected
section:
Press the Take over soft
key
 Start the simulation:
Press the Graphic
Continue soft key