HEIDENHAIN MANUALPLUS 4110 - Preparing Program Execution: Cycle Checking and Simulation; Checking Cycle Parameters Before Execution; Running a Graphic Program Simulation

HEIDENHAIN MANUALplus 4110 Executing Programs 11.3
Preparing program execution
Checking the cycle
The cycle parameters are displayed if you place the cursor on the cycle. Check the program
before running it.
Run a graphic simulation of the program
 Place the cursor at the
beginning of the program:
Press the Program start
soft key
 Place the cursor on the
cycle:
Press the arrow key
 Place the cursor at the
beginning of the program:
Press the Program start
soft key
 Press the Graphics soft key