HEIDENHAIN MANUALPLUS 4110 - Entering Machine Data for Setup; Key Machine Setup Functions; Machine Preparation Steps; Accessing Machine Data Entry Screen

HEIDENHAIN MANUALplus 4110 Machine Setup 6.1
Entering the machine data
Machine setup
The following functions are necessary for setting up the lathe:
 Activating a tool
 Entering technology data (shaft speed / cutting speed, feed rate, maximum speed)
 Setting the workpiece zero point
 Defining the protection zone
 Defining the tool-change point
Prepare the machine
Entering the machine data
 Clamp a workpiece
 Clamp tool T1
 Call the main menu:
Press the Menu key
 Select machine-data entry:
Press the Set S, F, and T
menu key