HEIDENHAIN MANUALPLUS 4110 - Tool Measurement: Loading File Data; Opening and Using the Tool File; Assumed Machine Data from File

HEIDENHAIN MANUALplus 4110 Tool Measurement 5.2
Preparing for tool measurement
Get a tool from the tool file:
 Open the tool file:
Press the Tool list soft key
 Assume tool T1:
Press the Take over tool
soft key
 Assume the cutting speed
and feed rate from the tool
file:
Press the S, F from tool
soft key
Entered and assumed machine data
 Tool number T: 1
 Cutting speed S: 200 m/min
 Feed rate per revolution F:
0.4 mm/rev
 Maximum shaft speed D: 2000 rev/min
 Stopping angle A: No entry
 Activate machine data:
Press the Save soft key
The maximum speed depends on the machine and the clamped workpiece.