HEIDENHAIN MANUALPLUS 4110 - Executing the Threaded Stud Cycle Program: Run Tool Change; Running the Tool Change Position Cycle

HEIDENHAIN MANUALplus 4110 Linear Machining Example 7.19
Create the “Threaded stud” cycle program
Run the cycle
 Test the cycle:
Press the Graphics soft key
(The bright dot is at the tool
change position.)
 Set the feed rate override feed rate override to 0%
 Activate Cycle Start
 Slowly increase the feed rate override. The tool moves to the tool change
position.
 Insert finishing tool T6
 Save the cycle:
Press the Save soft key