HER CHEE ADLY RT-50 - Chapter 5: Crank Case Disassembly

Chapter 6 CRANK CASE & CRANK SHAFT
Disassembly of Crank Case
Loosen all fixed bolts on crank case.
Install the puller on right crank case,
separate the R. crank case and L. crank
case.
: Crank case puller (TLJT-03)
Install the puller on left crank case,
remove the crank shaft from the crank
case.
: Crank case puller (TLJT-03)
Notice:
Don’t knock the crank shaft when
disassembling.
Use the bearing puller to remove the
crankshaft bearing from crank shaft, then
remove the R/L crank case.
: Bearing puller ( TLJT-00)
Notice:
Must remove the oil seal when
separate the crank case, and never use
the old oil seal.