Chapter 11 Electrical Device
Fuel Gage
Remove fuel gage.
Put the float to up end down end to
check the resistance between each
terminal.
Terminal of
Guide wire
Up end of
float
Down end
of float
Green &
black
0~20Ω 90~110Ω
Main Switch
Disconnect the connector of main switch
Check the conductivity between each
terminal.
Color tea
black/
red
black red
LOCK ○ ○
OFF ○ ○
ON ○ ○
Exchange
Remove front covering.
Remove 2 bolts, disconnect main switch
connector.
Install in reverse order of disassembly.
Handle Switch Assemble
Remove front covering.
Disconnect handle switch connector,
check conductivity between each
terminal.
Switch of Lights
Color Yellow/red Blue
OFF
ON ○ ○
Power Switch
Color blue/white Black
Up
Down ○ ○
Exchange of Bulbs
Head light bulb
Remove front covering of handle press
down the connection and turn it to
change head light bulb.
Dash light
Remove rear covering of handle pull
out the connection of bulb, and replace
the bulb.
Rear light / Brake light / Rear
direction light bulb
Remove 2 screws, pull out the light
Covering to front, disassembly hook on
light / brake light covering, and
disassembly light covering of direction
light and bulb, finally change bulb.
To Previous Page
Loading...