Hettich 4701 - ‎7.1.2 Runtime TIME‎

33 / 62
Rev.: 05 / 11.2023
AB4701en_SA
Software operation
Brake cut-off speed
Changing the runtime
Start of runtime count
4. If required: Press the [Ramp-up and ramp-down parameters] button
to set the next parameter.
5. Press the [START] button.
or
Press the [Ramp-up and ramp-down parameters] button repeatedly
until the centrifugation data is displayed.
1. Press the [Ramp-up and ramp-down parameters] button repeatedly
until the ‘N Brake’ parameter is displayed.
2. Use the [Rotary knob] to set the desired value.
3. The [Ramp-up and ramp-down parameters] button
or
Press the [START] button.
🡆 Settings are shown in the indicator.
7.1.2 Runtime TIME
For continuous operation, the minutes, seconds and hours
must be set to zero.
Continuous operation is indicated in the indicator by means
of the ‘¥’ symbol.
1. Press the [TIME] button.
🡆 ‘t/hms’ is displayed.
The minutes are displayed in brackets áñ.
2. Use the [Rotary knob] to set the desired value.
3. Press the [TIME] button.
🡆 The seconds are displayed in brackets áñ.
4.
Use the [Rotary knob] to set the desired value.
5.
Press the [TIME] button.
🡆 The hours are displayed in brackets áñ.
6.
Use the [Rotary knob] to set the desired value.
7.
Press the [START] button.
or
Press the [TIME] button repeatedly until the centrifugation data is
displayed.
🡆 Settings are shown in the indicator.
■ The ‘Dual time mode’ function is enabled. The function is enabled ex
works.
1.
Press the [TIME] button repeatedly until ‘Timing begins at Start’ or
‘Timing begins at Speed’ is displayed.