Hettich 4701 - ‎7.6.11 Indicator backlight‎

49 / 62
Rev.: 05 / 11.2023
AB4701en_SA
Software operation
4. Press the [PROG] button repeatedly until ‘Temp Unit = Fahrenheit’ or
‘Temp Unit = Celsius’ is displayed.
5. Use [Rotary knob] to set ‘Celsius (°C)’ or ‘Fahrenheit (°F)’ .
Celsius = values in Celsius (°C)
Fahrenheit = values in Fahrenheit (°F)
6. Press the [START] button.
🡆 The setting is stored.
‘Store Settings ...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [OPEN/STOP] button once to exit the ‘Settings’ menu
or
Press the [OPEN/STOP] button twice to exit the ‘Machine Menu’ .
7.6.11
Indicator backlight
For centrifuges with a program version from V01.18:
The indicator backlight can be switched off after 2 minutes to save energy.
1.
Press and hold the [PROG] button.
🡆 ‘***Machine Menu***’ is displayed after 8 seconds.
2. Press the [PROG] button repeatedly until ‘-> Settings’ is displayed.
3. Press the [START] button.
🡆 ‘SOUND / BELL = on’ or ‘SOUND / BELL = off’ is displayed.
4. Press the [PROG] button repeatedly until ‘ Power save = on’ or
‘ Power save = off’ is displayed.
Power save : Automatic switching off of the backlight
5. Use [Rotary knob] to set ‘off’ or ‘on’ .
off = disable automatic switch-off
on = automatic switch-off enabled
6. Press the [START] button.
🡆 The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [STOP/OPEN] button once to exit the ‘Settings menu’
or
Press the [STOP/OPEN] button twice to exit the ‘Machine Menu’ .