Fig. 26: Automatic circuit breaker
1 Plastic pin
The mains switch is in switch position
[O]
The centrifuge is disconnected from the mains.
1. Press the plastic pin (
1
) of the automatic circuit breaker.
2. Reconnect the device to the mains.
10 Disposal
10.1
General instructions
The device can be disposed of via the manufacturer.
A Return Material Authorisation (RMA) form must always be
requested for a return.
If necessary, contact the Technical Service Department of
the manufacturer.
− Andreas Hettich GmbH & Co.KG
− Föhrenstrasse 12
− 78532 Tuttlingen, Germany
− Phone: +49 7461 705 1400
−
E-mail: service@hettichlab.com
WARNING
Risk of pollution and contamination for people and the envi-
ronment.
When disposing of the centrifuge, people and the environ-
ment may be polluted or contaminated by incorrect or
improper disposal.
− Removal and disposal may be carried out only by a
trained and authorised service personnel.
The device is intended for the commercial sector ("Business to Business" -
B2B).
According to Directive 2012/19/EU, the devices may no longer be disposed
of with household waste.
The devices are assigned to the following groups according to the Stiftung
Elektro-Altgeräte Register (EAR (German foundation under civil law)):
■
Group 1 (heat exchangers)
■
Group 4 (large devices)
To Next Page
Loading...
