Hettich 4701 - ‎7.6.9 Centrifugation data displayed after switching on‎; ‎7.6.10 Setting a temperature unit (for centrifuges with cooling)‎

AB4701en_SARev.: 05 / 11.2023
48 / 62
Software operation
5. Press the [PROG] button.
🡆 ‘SOUND / BELL error = on’ or ‘SOUND / BELL error = off’ is
displayed.
‘SOUND / BELL error’ : Signal after the occurrence of a fault
6. Use [Rotary knob] to set ‘off’ or ‘on’ .
off = audible signal disabled
on = audible signal enabled
7. Press the [START] button.
🡆 The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
8. Press the [STOP/OPEN] button once to exit the ‘Settings menu’
or
Press the [STOP/OPEN] button twice to exit the ‘***Machine Menu***’ .
7.6.9 Centrifugation data displayed after switching on
The centrifugation data of program 1 or the last program used is displayed
after switching on.
1. Press and hold the [PROG] button.
🡆 ‘***Machine Menu***’ is displayed after 8 seconds.
2. Press the [PROG] button repeatedly until ‘-> Settings’ is displayed.
3. Press the [START] button.
🡆 ‘SOUND / BELL = on’ or ‘SOUND / BELL = off’ is displayed.
4. Press the [PROG] button repeatedly until ‘Start program = Last’ or
‘Start program = First’ is displayed.
5. Use [Rotary knob] to set ‘Last’ or ‘First’ .
Last = last program used
First = program 1
6. Press the [START] button.
🡆 The settings are stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the [STOP/OPEN] button once to exit the ‘Settings menu’
or
Press the [STOP/OPEN] button twice to exit the ‘Machine Menu’ .
7.6.10 Setting a temperature unit (for centrifuges with cooling)
The temperature can be entered in degrees Celsius (°C) or degrees Fahren-
heit (°F).
1. Press and hold the [PROG] button.
🡆 ‘***Machine Menu***’ is displayed after 8 seconds.
2. Press the [PROG] button repeatedly until ‘-> Settings’ is displayed.
3. Press the [START] button.
🡆 ‘SOUND / BELL = on’ or ‘SOUND / BELL = off’ is displayed.