Hettich 4701 - ‎7.7.3 Enabling or disabling program links‎; ‎8 Cleaning and care‎; ‎8.1 Overview table‎

51 / 62
Rev.: 05 / 11.2023
AB4701en_SA
Cleaning and care
3. Press the
[START] button.
🡆 ‘Multi program recall...’ is displayed briey.
The centrifugation data of the rst program of the program link is
displayed, along with the total runtime of the program link.
7.7.3 Enabling or disabling program links
1. Press and hold the
[PROG] button.
🡆 ‘***Machine Menu***’ is displayed after 8 seconds.
2. Press the
[PROG] button repeatedly until ‘-> Settings’ is displayed.
3. Press the
[START] button.
🡆 ‘SOUND / BELL = off’ or ‘SOUND / BELL = on’ is displayed.
4. Press the
[PROG] button repeatedly until ‘ Multi programs = off’ or
‘ Multi programs = on’ is displayed.
5. Use
[Rotary knob] to set ‘off’ or ‘on’ .
off = program link disabled
on = program link enabled
6. Press the
[START] button.
🡆 The setting is stored.
‘Store Settings...’ is displayed briey.
‘-> Settings’ is then displayed.
7. Press the
[STOP/OPEN] button once to exit the ‘Settings menu’
or
Press the [STOP/OPEN] button twice to exit the ‘Machine Menu’ .
8 Cleaning and care
8.1 Overview table
Chap. Task to execute
if required
daily
weekly
Annually
Page
8 Cleaning and care 51
8.3 Cleaning 52
8.3 Cleaning the device X 52
8.3 Cleaning the biosafety systems X 53
8.3 Cleaning the accessories X 53
8.4 Disinfection 53
8.4 Disinfecting the device X 53
8.4 Disinfecting the accessories X 54
8.5 Maintenance 54