HEX ezCAN - Page 23

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 23 of 60 ezCAN 2408.x
Adjusting Aux 2 lights
only
1. Hold the Multi-Controller RIGHT until the Aux 2 lights
flash twice.
 The Aux 2 lights are now in brightness-adjustment
mode.
2. Rotate the Multi-Controller UP to increase light
brightness by 10% per click (to a maximum of 100%), or
DOWN to decrease brightness by 10% per click (to a
minimum of 0%).
3. Exit brightness-adjustment mode by not operating the
Multi-Controller for more than 5 seconds.
Toggling Aux 1 lights
On and Off
Press and hold the turn-signal cancel button for more than 3
seconds. The state of the lights persists even if the ignition is
cycled.
Toggling Aux 2 lights
On and Off
Click the turn-signal cancel button three times. The state of
the lights persists even if the ignition is cycled.
Temporarily switching
off all front and rear
auxiliary lights
Press and hold the turn-signal cancel button for more than 5
seconds.
If all front and rear auxiliary lights are temporarily switched
off, the ezCAN will turn the rear auxiliary lights back on:
 Whenever Aux 1 or Aux 2 lights are turned back on.
 After the ignition switch is cycled.
Strobing Aux lights on
‘Flash-to-pass’
Click the motorcycle’s ‘Flash-to-pass’ button three times.
Note that to be active, this function must be enabled using
the ezCAN configuration interface.
5.1.1.2 Enabling and disabling front auxiliary light control functionality
If you do not want the BMW Multi-Controller and/or the turn-signal cancel
(TSC) button to be able to adjust front auxiliary lights, you can disable the
ezCAN control functionality of either or both of these controls.
To enable or disable ezCAN control functionality for the BMW Multi-
Controller and/or the BMW TSC button, do the steps that follow:
NOTES
If all front and rear auxiliary lights are temporarily switched
off (see table above), these lights will be switched back on
when the ignition is cycled.
Alternatively, Aux1 and/or Aux 2 lights can be switched
back on using the Toggling Aux 1/2 lights On and Off
functions (see table above).
When using the Toggling Aux 1/2 lights On and Off
functions, note that any rear auxiliary (Run/Brake) lights will
be switched back on whenever Aux 1 and/or Aux 2 lights
are switched back on.
IMPORTANT
Disabling ezCAN control functionality for the MultiController
and/or the TSC button does not affect their standard BMW
control functions.