HEX ezCAN - Page 24

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 24 of 60 ezCAN 2408.x
1. Click the drop-down menu button in the upper right corner of the
Auxiliary Lights One or Auxiliary Lights Two sections (below).
2. Click the Extra Settings option.
 The auxiliary lights Extra Settings menu will be shown.
Look for the following section:
 Both the switches are enabled (blue) by default.
3. To enable or disable the BMW Multi-Controller’s ezCAN control
functionality, click the Wonderwheel control enabled switch.
4. To enable or disable the BMW TSC button’s ezCAN control
functionality, click the Turn Signal Cancel enabled switch.
5.1.1.3 All Motorcycles without Multi-Controller
If an ezCAN is installed on any compatible BMW model without rotary
Multi-Controller, the ezCAN is controlled using the INFO button on the left-
side handlebar controls.
Adjusting Aux 1 lights
only
1. Press and hold the left switchgear INFO button until all
auxiliary front lights flash twice.
 The auxiliary front lights are now in brightness-
adjustment mode.
2. Release the INFO button.
3. Briefly press and release the INFO button to adjust light
brightness.
 Each press will brighten the Aux 1 lights by 10%
to a maximum of 100%, then roll brightness
through to 0% (OFF).
 You can repeat this cycle as many times as you
need.
4. Exit brightness-adjustment mode by not operating the
INFO button for more than 5 seconds.