HEX ezCAN - Page 39

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 39 of 60 ezCAN 2408.x
Adjusting Aux 1 lights
only
1. Make sure the motorcycle’s cruise control is deactivated.
2. Press and hold the +/RES button until the Aux 1 lights
flash twice.
 The Aux 1 lights are now in brightness-adjustment
mode.
3. Briefly press and release the +/RES button to increase
light brightness by 10% per click (to a maximum of
100%), or the -/SET button to decrease brightness by
10% per click (to a minimum of 0%).
4. Exit brightness-adjustment mode by not operating the
+/RES or -/SET buttons for more than 5 seconds.
Adjusting Aux 2 lights
only
1. Make sure the motorcycle’s cruise control is deactivated.
2. Press and hold the -/SET button until the Aux 2 lights
flash twice.
 The Aux 2 lights are now in brightness-adjustment
mode.
3. Briefly press and release the +/RES button to increase
light brightness by 10% per click (to a maximum of
100%), or the -/SET button to decrease brightness by
10% per click (to a minimum of 0%).
4. Exit brightness-adjustment mode by not operating the
+/RES or -/SET buttons for more than 5 seconds.
Toggling Aux 1 lights
On and Off
1. Make sure the motorcycle’s cruise control is deactivated.
2. Click the +/RES button three times.
 The state of the lights persists even if the ignition
is cycled.
 This function is disabled if the Aux1 on/off with OE
Fog light setting is enabled in the ezCAN settings
menu.
As an alternative, the Aux 1 lights can be controlled using the
motorcycle’s fog light button (see Switching auxiliary lights on
and off using the DRL/Fog light button).
Toggling Aux 2 lights
On and Off
1. Make sure the motorcycle’s cruise control is deactivated.
2. Click the -/SET button three times.
 The state of the lights persists even if the ignition
is cycled.
 This function is disabled if the Aux2 on/off with OE
Fog light setting is enabled in the ezCAN settings
menu.
As an alternative, the Aux 2 lights can be controlled using the
motorcycle’s fog light button (see Switching auxiliary lights on
and off using the DRL/Fog light button).
Temporarily switching
off all front and rear
auxiliary lights
1. Make sure the motorcycle’s cruise control is deactivated.
2. Press and hold the +/RES button for more than 10
seconds.
 All front and rear auxiliary lights will be temporarily
switched off. The auxiliary lights will be switched
back on when the ignition switch is cycled.
IMPORTANT
Switch off the motorcycle’s cruise control function before
adjusting auxiliary light brightness. The ezCAN will not
respond to inputs from the cruise control buttons while the
motorcycle’s cruise control function is active.