HEX ezCAN - Page 42

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 42 of 60 ezCAN 2408.x
If the Aux 1 on/off with OE Fog lights and/or the Aux 2 on/off with OE Fog
lights settings are enabled, the Aux 1 and/or Aux 2 lights mimic the on/off
state of the motorcycle’s fog lights. The fog light tell-tale on the
motorcycle’s instrument cluster shows you whether the fog light state is on
or off.
To switch auxiliary lights on and off using the DRL/Fog light button, do
ONE of the steps that follow:
 If the motorcycle has factory daytime running lights (DRL) fitted,
long-press (press and hold) the DRL/Fog light button to toggle the
Fog light/auxiliary light state.
 If the motorcycle does not have factory DRL fitted, short-press
(briefly press and release) the DRL/Fog light button to toggle the
Fog light/auxiliary light state.
5.1.7.1.2 Switching auxiliary lights on and off using the Cruise Control buttons
If you want to use only the motorcycle’s DRL/Fog light button to switch
auxiliary lights on and off, disable on/off control of the front auxiliary lights
through the motorcycle’s cruise control buttons by doing the steps that
follow:
1. Click the Extra Settings button in the upper right corner of the
Auxiliary Lights One or Auxiliary Lights Two sections of the ezCAN
user interface (below).
2. Locate the Vehicle switchgear controls section of the drop-down
menu (below).
3. To enable switching of all auxiliary lights on and off using the
motorcycle’s cruise control buttons, switch the Cruise control
buttons option to ON (enabled by default).
IMPORTANT
If the Aux 1 on/off with OE Fog lights and/or the Aux 2
on/off with OE Fog lights settings are set to ON, auxiliary
lights can only be switched on and off using the DRL/Fog
light button, and the +/RES and -/SET buttons cannot be
used.
This does not affect control of auxiliary light brightness
adjustment, or temporary switching off of all front and rear
auxiliary lights, through the cruise control buttons.