Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 46 of 60 ezCAN 2408.x
Temporarily switching
off all front and rear
auxiliary lights
Press and hold the ABS ON button until the Aux lights fade
off, then continue to hold the button for another five
seconds.
All front and rear auxiliary lights will be temporarily
switched off.
The auxiliary lights will be switched back on when
the ignition switch is cycled.
The Aux lights can also be switched on by toggling
the Aux1 lights on or off as described above.
Strobing Aux lights on
‘Flash-to-pass’
Click the motorcycle’s ‘Flash-to-pass’ button three times.
Note that to be active, this function must be enabled using
the ezCAN configuration interface.
5.1.8.1.1 Disabling auxiliary light control by the motorcycle controls
Depending on your preference, you may want to use only the ezCAN
configuration interface to control the auxiliary lights. In this case, you can
disable control of the front auxiliary lights through the motorcycle’s
controls by doing the steps that follow:
1. Click the Extra Settings button in the upper right corner of the
Auxiliary Lights One or Auxiliary Lights Two sections of the ezCAN
user interface (below).
2. Locate the Vehicle switchgear controls section of the drop-down
menu (below).
3. Do ONE of the steps that follow:
NOTES
If all front and rear auxiliary lights are temporarily switched
off (see table above), these lights will be switched back on
when the ignition is cycled.
Alternatively, Aux1 and/or Aux 2 lights can be switched
back on using the Toggling Aux 1/2 lights On and Off
functions (see table above).
When using the Toggling Aux 1/2 lights On and Off
functions, note that any rear auxiliary (Run/Brake) lights will
be switched back on whenever Aux 1 and/or Aux 2 lights
are switched back on.
To Next Page
Loading...
