Wi-Fi 6 2x2:2 User Manual Rev: A0-00
77
CONFIDENTIAL
Callout Name Description
7. IPv4-Gateway
Enter the IP address of the gateway in IPv4 format
through which the destination host or network can be
reached. If the current AP is being used to connect
network with the Internet, then your gateway IP is the
AP's IP address. If you have another router handling your
network's Internet connection, enter the IP address of
that router instead
8. Metric
Enter a value that defines the priority of the route. If
multiple routes to the same destination exist, the route
with the lowest metric is chosen
9. MTU Enter the MTU size, by default it is set to 1500.
Click “Save & Apply” to save the static IPv4 route configuration or click “Reset” to configure the same again.
Static IPv6 Routes
10. Add
Click on “Add” option to add a new static route in IPv6
format
11. Interface
Select the physical network interface through which this
route is accessible from the dropdown list
12. Target
Enter the IP address of the destination host or network in
IPv6 format to which the route leads
13. IPv6-Gateway
Enter the IP address of the gateway in IPv6 format
through which the destination host or network can be
reached. If the current AP is being used to connect
network with the Internet, then your gateway IP is the
AP's IP address. If you have another router handling your
network's Internet connection, enter the IP address of
that router instead
14. Metric
Enter a value that defines the priority of the route. If
multiple routes to the same destination exist, the route
with the lowest metric is chosen
15. MTU Enter the MTU size, by default it is set to 1500.
Click “Save & Apply” to save the static IPv6 route configuration or click “Reset” to configure the same again.
To Next Page
Loading...