HikRobot ID5000 Series - Output Signal Wiring

ID5000 Series Smart Code Reader User Manual
9
Device Power
PWR
Device Power Ground
NPN
Device
NPN Device Power
VCC
GND of PWR
Input Signal
Ground
GND of VCC
Opto-Isolated Input
Signal Line
NPN Power Ground
Figure 3-6 Input Signal Connecting to NPN Device without Pull-Up Resistor
If the VCC of NPN device is 12 VDC or 24 VDC and 1 KΩ pull-up resistor is used, its wiring is as
follows.
Opto-Isolated
Input
Device Power
PWR
Device Power Ground
NPN
Device
NPN Device Power
NPN Power Ground
Signal Line
VCC
GND of PWR
Input Signal Ground
GND of VCC
Figure 3-7 Input Signal Connecting to NPN Device with Pull-Up Resistor
3.4 Output Signal Wiring
The device can output signal to external device via I/O interface, and here we take LineOut 0 and
type I device as an example to introduce output signal wiring.
Note
● Output signal wiring may differ with different types of external devices.
● The voltage of VCC should not higher than that of PWR. Otherwise, the device's output signal
may have exception.