ID5000 Series Smart Code Reader User Manual
78
8.8.4 Serial
If Serial is selected as the Communication Protocols, you can enable Serial Protocol, enter Serial
Baud Rate, Serial Data Bits, Serial Parity, and Serial Stop Bits.
Figure 8-61 Serial
8.8.5 FTP
If FTP is selected as the Communication Protocols, you can enable FTP Protocol, enter FTP Host
Addr, FTP Host Port, FTP User Name, and FTP User PWD.
Figure 8-62 FTP
8.8.6 Profinet
If Profinet is selected as the Communication Protocols, you can enable Profinet Enable and set
Profinet Device Name according to actual demands.
To Next Page
Loading...
