ID5000 Series Smart Code Reader User Manual
25
Figure 8-1 Set Image
8.1.2 Set Exposure
The device supports four types of exposure modes, including off, once, continuous, and alternate.
Refer to the table below for details.
Table 8-1 Exposure Mode
The device exposures according to the value configured by the user in
Exposure Time (μs).
The device adjusts the exposure time automatically according to the image
brightness. After adjusting once, the device will switch to off mode.
The device adjusts the exposure time continuously according to the image
brightness.
The device exposures alternately according to multiple groups of exposure
time configured by the user.
Once or Continuous Exposure
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Image Setting, and select Once or Continuous as Exposure Auto according to actual
demands.
3. Select Global or Partial as Exposing Area according to actual demands.
4. (Optional) Set specific exposure area if Partial is selected.
●
Area Width: It refers to the horizontal resolution in partial exposure area.
●
Area Height: It refers to the vertical resolution in partial exposure area.
●
Offset X: It refers to the horizontal coordinate of the upper left corner in partial exposure area.
●
Offset Y: It refers to the vertical coordinate of the upper left corner in partial exposure area.
To Next Page
Loading...
