ID5000 Series Smart Code Reader User Manual
45
ā
The code score is determined by two factors including image quality and print quality of codes.
The range of code score is between 0 and 100, and the higher the score, and easier the code can
be read.
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Algorithm Control, and enable Code Score Enable.
Figure 8-22 Enable Code Score
3. Click to start acquisition, and the client software will display specific code score in the
history area.
Figure 8-23 Code Score
4. (Optional) Go to Image Settings, and adjust parameters like exposure time, gain, Gamma, light
source, etc. if the code score is low.
Note
If the code score is still low after adjusting, and the code may have poor printing quality.
8.3 Signal Input Settings
In the signal input module, you can set the trigger related parameters. You can enable trigger
mode to let the acquisition of image data occur only when the trigger source is generated.
8.3.1 Set Trigger Mode
The device has 2 types of trigger modes, including internal trigger mode and external trigger
To Next Page
Loading...
