ID5000 Series Smart Code Reader User Manual
33
Manual Focus
1. Go to Image Settings → Auto Focus, and set Focus Step according to actual demands.
2. Click or in Adjust Focus to adjust focus.
3. Select the position parameter from Focus Position, and click Execute in Focus Position Save to
save the focus position.
4. (Optional) Select the position parameter from Focus Position, and click Execute in Focus
Position Load to load saved focus position.
Figure 8-11 Manual Focus
8.1.7 Set Self-Adaptive Adjustment
Note
This function may differ by device models.
The function of self-adaptive adjustment can automatically adjust exposure, gain, Gamma and other
parameters to have a better code reading effect.
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Self Adapt Adjust, and select Adjust Mode.
●
High Quality: In this mode, the client software will adjust exposure in priority with small gain and
noise. The image quality is high, and this mode is applicable to the scenario for low speed
conveyer belt.
●
High Speed: In this mode, the client software will adjust gain in priority with small exposure and
large gain. The image quality is less high, and this mode is applicable to the scenario for high speed
conveyer belt.
3. Select Param Source according to actual demands.
●
Default Param: It adjusts the default parameters.
●
Polling Param: It adjusts parameters configured in polling.
To Next Page
Loading...
