ID5000 Series Smart Code Reader User Manual
35
8.1.9 Set Test Pattern
Test pattern helps troubleshooting image problems and images in the test pattern are only for test.
When exceptions occur in images acquired by the device in real time, you can check if images in the
test pattern have similar problems to determine the cause of an exception.
Note
●
The test pattern is available in the test or raw device mode.
●
Specific parameters of this function may differ by device models.
Go to Image Settings, click All Features, find Test Pattern in Other Features, and set Test Pattern
according to actual demands.
8.2 Code Algorithm Settings
The code reader supports reading multiple types of 1D code and 2D code, and you can add and set
code parameters via the client software.
8.2.1 Add Code
Adding code before you set code parameters via the client software. In Algorithm Settings, you can
add different types of codes according to actual demands.
In Algorithm Settings, click Add Barcode, select the types of codes to be read, and set the 1D Code
Number and 2D Code Number according to actual demands.
Note
●
For different models of the device, the specific parameters may differ, and the actual device you
purchased shall prevail.
●
Selected symbology amount and added code amount may affect the code recognition time.
Note that selecting more symbologies or adding more codes may consume more time to
recognize codes in the image.
●
No matter 1D code or 2D code, up to 20 codes can be added at a time. Note that adding more
codes may consume more time to recognize codes in the image. Therefore, the code number is
recommended to be set according to the actual demands.
●
The code reader may output actual code number when the mismatch between the actual code
number and the code number set in the client software occurs.
To Next Page
Loading...
