HikRobot ID5000 Series - Code Reading Result Settings; Set Code Reading Result Output Mode; Set Filter Rule

ID5000 Series Smart Code Reader User Manual
65
No.
Parameters
Description
7
LineOut 1
The indicators flash once when LineOut 1 outputs signals.
8
LineOut 2
The indicators flash once when LineOut 2 outputs signals.
Figure 8-54 Indicator Customization
8.6 Code Reading Result Settings
In Data Processing module, you can set filter rules for reading barcodes and other data processing
related parameters.
8.6.1 Set Code Reading Result Output Mode
There are 2 types of output modes when the device mode is Normal and trigger mode is On: Instant
output mode and non-instant output mode.
● Instant output mode means that the device can instantly output code reading results when
recognizing codes if you enable Instant Output Mode Enable in Filter Rule.
● Non-instant output mode means that the device does not output code reading results it
recognized until the trigger stops if Instant Output Mode Enable is not enabled. If the device does
not recognize any codes during the whole process, images it captured will be output, and you can
set which images to be outputted in NoRead Image Index.
When the device mode is Normal and trigger mode is Off, you can set Filter Time in Filter Rule.
Within the configured Filter Time, the device will not output any code information.
Note
The filter rule and data processing parameters may differ with different device modes and trigger
modes.
8.6.2 Set Filter Rule
You can set rules to filter unwanted barcodes to improve the reading efficiency in Filter Rule. Two
filter modes are available, including normal mode and regular expression mode. You can set it in