HikRobot ID5000 Series - Fins

ID5000 Series Smart Code Reader User Manual
81
ModBus Control Address Offset
It refers to the address offset, and is 0 by default.
ModBus Control Data Number
It is 2 by default.
ModBus State Address Space
It is input_register by default.
ModBus State Address Offset
It is 0 by default.
ModBus State Data Number
It is 2 by default.
ModBus Result Address Space
It is input_register by default.
ModBus Result Address Offset
It is 4 by default.
ModBus String Byte Swap
If it is enabled, string byte is saved by big-endian. If it is not enabled, string byte is saved by
little-endian.
Figure 8-66 ModBus
8.8.10 Fins
If Fins is selected as the Communication Protocols, you can enable Fins Enable and set related