HikRobot ID5000 Series - Indicator Customization

ID5000 Series Smart Code Reader User Manual
64
Select Compare Fail
If you select Compare Fail as Line Out Activation Event, you can set its output delay time and
duration.
Line Out Delay Time
It sets the delay time for outputting the output signal.
Line Out Duration
It sets the time duration of the output signal.
Figure 8-53 Select Compare Fail
8.5 Indicator Customization
The device has 2 user-defined indicators, U1 and U2. They are used to indicate whether some
functions of the device are normal or not after you selecting specific events.
Go to I/O Control Settings → LED, and set corresponding events according to actual demands.
When the event you select occurs, indicators will flash once.
Table 8-3 Indicator Description
No.
Parameters
Description
1
Off
No events.
2
Read Success
The indicators flash once when the device reads codes.
3
Who Am I
After selecting Who Am I, you can click Execute to let indicators
flash, and know which device you are operating.
4
System Running
The indicators flash once when the device system operates.
5
Be Triggered
The indicators flash once when the device receives trigger
signals.
6
LineOut 0
The indicators flash once when LineOut 0 outputs signals.