ID5000 Series Smart Code Reader User Manual
26
Figure 8-2 Once or Continuous Exposure
Alternate Exposure
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Image Setting, and enable Exposure Alternate.
3. Select one exposure parameter from Exposure Index.
4. Enable Exposure Enable and enter Exposure Time according to actual demands.
5. Repeat step 3 and step 4 to set multiple exposure parameters according to actual demands.
Figure 8-3 Alternate Exposure
Note
The alternate exposure parameter may differ by device firmware versions and models.
8.1.3 Set Gain
The device supports four types of gain modes, including off, once, continuous, and alternate. Refer
to the table below for details.
To Next Page
Loading...
