HikRobot ID5000 Series - Page 36

ID5000 Series Smart Code Reader User Manual
27
Table 8-2 Gain Mode
Gain Mode
Description
Off
The device adjust gain according to the value configured by the user in Gain (dB).
Once
The device adjusts gain automatically according to the image brightness. After
adjusting once, the device will switch to off mode.
Continuous
The device adjusts gain continuously according to the image brightness.
Alternate
The device adjusts gain alternately according to multiple groups of gain configured
by the user.
Once or Continuous Gain
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Image Setting, and select Once or Continuous as Gain Auto according to actual demands.
Figure 8-4 Once or Continuous Gain
Alternate Gain
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Image Setting, and enable Gain Alternate.
3. Select one gain parameter from Gain Index.
4. Enable Gain Enable and enter Alternate Gain.
5. Repeat step 3 and step 4 to set multiple gain parameters according to actual demands.
Figure 8-5 Alternate Gain
Note
The alternate gain parameter may differ by device firmware versions and models.