HikRobot ID5000 Series - Chapter 4 Installation; Installation Preparation

ID5000 Series Smart Code Reader User Manual
12
Chapter 4 Installation
4.1 Installation Preparation
You need to prepare following accessories before installation.
Table 4-1 Accessories
No.
Name
Quantity
Description
1
Power and I/O Cable
1
It refers to the 3-meter 12-pin power and I/O cable, and is
included in the package.
2
Network Cable
1
It refers to the 3-meter GigE network cable with RJ45 connector
and aviation connector. It is included in the package.
3
DC Switch Power
Supply
1
It refers to DC switch power supply of 24 VDC and above 1A/2A.
Refer to the specification of the device for detailed power
supply information. You need to purchase separately.
4
Lens
1
It refers to C-mount lens that you need to purchase it
separately. The C-mount lens is used for the type III device.
Note
The type II device is equipped with M12-mount lens.
5
Light Source
1
It is used to provide light during image acquisition. You need to
purchase separately.
6
Fixed Bracket
1
It is used to fix the device. You need to purchase separately.
7
M4 Screw
4
It refers to the supplied M4 screw that is used to fix the device
to installation position.
4.2 Install Device
Before You Start
● Make sure the device in the package is in good condition and all the assembly parts are
included.
● Make sure that all the related devices are powered off during the installation.
Note
Here we take the type I device as an example for introducing installation.