HikRobot ID5000 Series - Page 38

ID5000 Series Smart Code Reader User Manual
29
are enabled, the polling order is Param3 > Param1 > Param2 > Param4 > Param5.
Steps
1. Go to Image Settings → Image → Polling Enable, and select Multiple as Polling Enable.
2. Set Polling Time and Polling Period according to actual demands.
3. Select 2 to 8 sets of parameters (e.g. Param1 and Param2) from Polling Param, and enable
Polling Param Enable to let them take effect.
4. Set Polling Exposure Time, Polling Gain, and Polling Gamma for the Polling Param you selected.
5. Select Polling Light Selector according to actual demands, and enable Polling Light Enable.
6. Repeat step 3 to step 5 to set other parameters from Polling Param.
Figure 8-7 Multiple Mode
Parameter 1
Exposure Time 1
Gain 1
Gamma 1
Lighting 1
Parameter 2
Exposure Time 2
Gain 2
Gamma 2
Lighting 2
Parameter 3
Exposure Time 3
Gain 3
Gamma 3
Lighting 3
Parameter 4
Exposure Time 4
Gain 4
Gamma 4
Lighting 4
Parameter 8
Exposure Time 8
Gain 8
Gamma 8
Lighting 8
Parameter 7
Exposure Time 7
Gain 7
Gamma 7
Lighting 7
Parameter 6
Exposure Time 6
Gain 6
Gamma 6
Lighting 6
Parameter 5
Exposure Time 5
Gain 5
Gamma 5
Lighting 5
Figure 8-8 Polling Diagram