Video Security Control Panel User Manual
2. Click the drop down menu to select a center group.
3. Check the Enable checkbox to enable the configuration
4. Check the checkbox to select the required Zone for sending the Zone report for the Zones without Zone
report.
At most 6 center groups can be inter-combined to send the alarm report.
5. Check the checkbox to select the type of non-Zone alarm report.
6. Click each dropdown menu to configure the uploading channel.
7. Click Apply to save the settings.
The alarm channel of each center group should be configured in order.
Network Center Settings
Purpose:
In this section, you can configure the parameters(such as server type, IP address, port NO.,and so on)of the
network center.
Steps:
1. Enter the network center configuration page.
Remote Settings->Network Center
To Next Page
Loading...
Need help?
General
