Video Security Control Panel User Manual
Partition Zone Settings
The programming command of zone configuration of the partition is shown below.
{1} The programming command addressof zone configuration is 531～538.
{2} The configuration item of 3 indicates zone configuration of the partition.
{3} Add/Delete Zone
{4} Zone No.
{5} End the command.
There are three mode to add/delete zone for the partition , adding/deleting separately, Adding/ Deleting
continually and adding/deleting in Batch, for details, refer to the Partition Keypad User Settings.
Partition Keypad Settings
The programming command of keypad configuration of the partition is shown as follows.
{1} The programming command address of zone configuration is 531～538.
{2} The configuration item of 4 indicates keypad configuration.
{3} Add/Delete Keypad
To Next Page
Loading...
Need help?
General
