HIKVISION DS-2CD6986F-H - 7.2 Maintenance

User Manual of PanoVu Series Network Camera
96
2. Set the RS-485 parameters and click to save the settings.
Note:
The Baudrate, PTZ Protocol and PTZ Address parameters of the camera should be exactly the
same as those of the control device.
7.1.4 Configuring DST (Daylight Saving Time)
Purpose:
If there is the habit of adjusting clocks forward in your country in certain time period of a year, you
can turn this function on. The time will be adjusted automatically when the Daylight Saving Time
(DST) comes.
Steps:
1. Enter the DST settings interface:
Configuration > System > System Settings > DST
2. Check to enable the DST function.
3. Set the date of the DST period.
4. Click to save the settings.
Figure 7-7 DST Settings
7.2 Maintenance
7.2.1 Upgrade & Maintenance
 Rebooting the Camera
Steps:
1. Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance:
2. Click to remotely reboot the camera.
 Restoring Default Settings
Steps:
1. Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance:
2. Click or to restore the default settings.