HIKVISION DS-2CD6986F-H - 4.2 PTZ Configuration

User Manual of PanoVu Series Network Camera
45
4.2 PTZ Configuration
4.2.1 Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset freezing, preset
speed, etc.
1. Enter the Basic PTZ parameter configuration interface:
Configuration > PTZ > Basic Settings
Figure 4-7 Basic PTZ Configuration Interface
2. Configure the following settings:
 Basic Parameters: Enable/disable proportional pan and preset freezing, set the preset speed,
manual control speed, keyboard control speed, auto scan speed, and zooming speed.
 Proportional Pan: If you enable this function, the pan/tilt speeds change according to the
amount of zoom. When there is a large amount of zoom, the pan/tilt speed will be slower
for keeping the image from moving too fast on the live view image.
 Preset Freezing: This function enables the live view to switch directly from one scene
defined by a preset to another, without showing the middle areas between these two, to
ensure the surveillance efficiency. It can also reduce the use of bandwidth in a digital
network system.
Note:
Preset freezing function is invalid when you calling a pattern.
 Preset Speed: You can set the speed of a defined preset from 1 to 8.
 Manual Control Speed: The manual control speed can be set as Compatible, Pedestrian,
Non-motor Vehicle, Motor Vehicle or Auto.